2005 Toyota Sequoia Remote Programming Instructions
Written by Cole Fuquay
Updated at June 26th, 2024
- Key Cutting Equipment
- Universal EZ Installer
- On Board Programming
- Pairing Equipment
- Simple Keys
- Support Documentation
- Universal Remotes
- Vehicle Information
- NASTF Resources
- FAQs
- Latest Updates
- OEM Programmers
- CKE Programmer Manuals (dongles)
- ROKS Box Information
- Programming Advice
- General Key Information
- Start with key out of the ignition, the driver’s door is open, all others are closed, and the driver’s door is unlocked.
- Insert the key into ignition (Do NOT turn) and pull it out.
- Perform these steps within 40 seconds.
- Using the power door lock switch on DRIVER’S door, perform 5 LOCK/ UNLOCK cycles starting with lock. Use an even pace and try to go about one cycle per second. (1 cycle = 1 LOCK and UNLOCK).
- Close, then open DRIVER’S door.
- Perform these steps within 40seconds.
- Using the power door lock switch on DRIVER’S door, perform 5 LOCK/ UNLOCK cycles starting with lock. Use an even pace and try to go about one cycle per second. (1 cycle = 1 LOCK and 1 UNLOCK).
- Insert the key in the ignition cylinder.
- Turn the ignition to ON (Do NOT start) then back to OFF.
- Turn the ignition to ON (Do NOT start) then back to OFF.
- Remove the key from the ignition.
- Within 3 seconds the power door locks should cycle automatically indicating successful entry into PAIRING MODE. Return to Step #1 if the locks do not cycle at this point.
- Perform these steps within 40 seconds.
- Press the LOCK and UNLOCK buttons on the remote simultaneously for 1 second.
- Immediately after letting go of the LOCK and UNLOCK buttons, press the LOCK button by itself 2 seconds. Within 3 seconds the door locks should cycle once indicating successful pairing. If the door locks don’t cycle or cycle twice, repeat steps A and B, your remote has not been accepted.
- Repeat steps A and B in Step #6 for each new remote.
- Close DRIVER’S door.
- Test all remotes.