2007 Infiniti FX Remote Programming Instructions
Written by Cole Fuquay
Updated at June 24th, 2024
- Key Cutting Equipment
- Universal EZ Installer
- On Board Programming
- Pairing Equipment
- Simple Keys
- Support Documentation
- Universal Remotes
- Vehicle Information
- NASTF Resources
- FAQs
- Latest Updates
- OEM Programmers
- CKE Programmer Manuals (dongles)
- ROKS Box Information
- Programming Advice
- General Key Information
Table of Contents
These Instructions are for vehicles without Smart Entry System/SES
NOTE: Withdraw key completely from the ignition cylinder each time. If this procedure is performed too fast, the system will not enter Programming mode.
- Close and lock all doors with the driver's side power lock/unlock switch.
- Insert the key into the ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step.
- Insert the key into the ignition cylinder and turn to the ACC position.
- Within 5 seconds, push ANY button on the new remote. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the Programming procedure will not be successful.
- If there are any remaining remotes (including the old ones), unlock them then lock all doors using the driver's side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each remote (including any existing remotes).
- Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver's side power lock/unlock switch and open the driver side door.