1995 Chevrolet Suburban Remote Programming Instructions
Written by Cole Fuquay
Updated at September 27th, 2024
- Key Cutting Equipment
- Universal EZ Installer
- On Board Programming
- Pairing Equipment
- Simple Keys
- Support Documentation
- Universal Remotes
- Vehicle Information
- NASTF Resources
- FAQs
- Latest Updates
- OEM Programmers
- CKE Programmer Manuals (dongles)
- ROKS Box Information
- Programming Advice
- General Key Information
- Locate the Data Link Connector (DLC) underneath the driver's side dashboard. Use the figure as a map for your DL ( They are not lettered on your vehicle.)
- Connect cavity G to a ground. Your vehicle will respond by locking and unlocking the door locks within 2 seconds.
- Press the lock or unlock button on the first remote to be programmed. Locks will lock and unlock verifying remote was programmed.
- Press the lock or unlock button on the second remote to be programmed if applicable.
- Locks will lock and unlock to verify the remote was programmed.
- Remove jumper wire and test remote(s)