1999 Mitsubishi Eclipse Remote Programming Instructions
Written by Cole Fuquay
Updated at March 27th, 2024
- Key Cutting Equipment
- Universal EZ Installer
- On Board Programming
- Pairing Equipment
- Simple Keys
- Support Documentation
- Universal Remotes
- Vehicle Information
- NASTF Resources
- FAQs
- Latest Updates
- OEM Programmers
- CKE Programmer Manuals (dongles)
- ROKS Box Information
- Programming Advice
- General Key Information
- Locate the Data Port/OBD2 Port. (Most commonly located on driver's side under steering column)
- Insert the key into the ignition and leave in the off position.
- Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port with a suitable jumper wire, leave jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
- Within 10 seconds after connecting the jumper wire, turn the ignition switch to the ACC position and then back to off. The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
- Press the lock button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
- If there are two remotes, register the first, then register the second.
- Repeat step 5 within one minute to program second remote.
- After completing the second programming, the doors will lock and unlock once.
- Disconnect the programming wire and remove the keys from the ignition.