NOTE: This procedure is for Programming conventional key fobs only. The Remote Keyless Entry (RKE) remote of the integrated Keyhead remote  is programed automatically during the Passive Anti-Theft System (PATS) Programming. All RKE remotes must be programmed at the same time. Do not apply the brake pedal during this sequencing, as doing so ends the sequence and the remotes will not be programmed. Four remote maximum may be programmed to one vehicle.

1. Electronically unlock the door locks using the door lock control switch.
2. Cycle the ignition switch from the OFF to the RUN position 8 times in rapid succession (within 10 seconds), with the eighth turn ending in RUN. If the module successfully enters program mode, it locks and then unlocks all the doors.
3. Within 20 seconds, press any button on the RKE remote to be programmed. The doors lock and then unlock to confirm that each RKE remote is programmed. Repeat this step for each RKE remote.
4. If no action is taken within 20 seconds after a remote has been programmed, the Programming sequence ends (the doors lock and unlock to confirm that Programming is complete).
5. Exiting the Programming mode is accomplished if one of the following occurs: The key transitions to the OFF position, 20 seconds have passed since entering Programming mode, or since the last RKE remote was programmed. The maximum number (4) of RKE remotes have been programmed. Check the operation of the RKE remote. If the door locks do not respond for the programmed RKE remote(s), wait several seconds and press the button again.